Amiga Zorro II
Zorro II is the general purpose expansion bus used by the Amiga 2000 computer. The bus is mainly a buffered extension of the Motorola 68000 bus, with support for bus mastering DMA. The expansion slots use a 100-pin connector and the card form factor is the same as the IBM PC. Zorro II cards implement the Autoconfig protocol for automatic address space assignment (similar to the later PCI technology on the PC).
The prototype "Zorro bus" expansion box for the Amiga 1000 was the basis for the initial Amiga 2000-A model design. This box connected to the Amiga 1000 unbuffered CPU bus card edge connector.
Zorro II was succeeded by Zorro III, a 32-bit, asynchronous bus.
Amiga memory map
| Address | Size [MByte] | Description |
|---|---|---|
| 0x00 0000 | 2.0 | Chip memory |
| 0x20 0000 | 8.0 | Zorro II memory expansion space |
| 0xA0 0000 | 1.5 | Zorro II I/O expansion space |
| 0xB8 0000 | 3.0 | A2000 motherboard register space |
| 0xE8 0000 | 0.5 | Zorro II I/O |
| 0xF0 0000 | 1.0 | Motherboard ROM |
External links
- Amiga Hardware Database - Descriptions and photos of Zorro II cards.
- Discussion about speed of Zorro
| General | |
|---|---|
| Standards |
|
| Storage | |
| Peripheral | |
| Audio | |
| Portable | |
| Embedded | |
Interfaces are listed by their speed in the (roughly) ascending order, so the interface at the end of each section should be the fastest.  Category | |
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.