IBM PS/2 portable computers

The IBM P75 in its travelling configuration resembles a briefcase with a carrying handle - all components such as the screen, floppy disk drive and keyboard are stowed away behind the keyboard during transport. To use the computer, one places the computer on a desk and opens the latches at either side of the front of the computer to release the keyboard, which swings down. The keyboard can then be fully released from the main unit and height adjusted for comfort. The screen viewing angle can also be adjusted by pulling on tabs on either side of the screen. To access the floppy drive, one pushes on a raised square on the floppy drive disk cover to release it.[1][5]

The IBM P75 has similar specifications to an IBM model 90, but has been made into a portable. It features an Intel i486-DX 33 CPU that is housed on a processor complex card separate from the motherboard. The computer uses IBM's Micro Channel architecture (MCA) bus and has 4 internal bus slots: one 32-bit AVE, one 32-bit MME, and two 16-bit short slots.[6]

The internal gas plasma display of the IBM P75 is XGA/VGA, EGA, MCGA, CGA compatible, and operates at a maximum 640×480 in 16 shades of grey in VGA mode. The IBM P75 can drive its internal monitor and an external monitor simultaneously. When driving the external monitor only, it can operate at 800x600 resolution in 16-bit (high-colour) in Windows 95 using third party drivers.[7]

The keyboard is a 101 key, full size and full travel IBM keyboard and serves as both the keyboard of the unit and the cover of the unit when being transported. It is attached to the computer through a 14-inch rolled-coil cable.[5]

Hard disk configurations were available in 2 varieties, a 160 MB SCSI hard disk drive (model 8573-161) or a 400 MB SCSI (model 8573-401), with the onboard SCSI controller being capable of handling drives up to 1GB.[3]

The IBM P75 supports up to 16 megabytes of Random-access memory through 4 SIMM slots on the motherboard, each of which can accept a 2 MB or 4 MB 70 nanosecond SIMM. The SIMM must be manufactured by IBM for the computer to accept them – non-IBM SIMMs or generic SIMMs that do not utilise the "presence detect" feature cannot be used unless modified. The stock configuration of RAM on IBM P75 is 8 MB.[8]

The IBM P75 featured numerous ports, including an external SCSI connector, a parallel port, a serial port, a PS/2 mouse port, an external 5.25" floppy disk port, and a VGA port. The ports are housed behind a door on the rear of the unit which allows for them to be hidden when not in use. The recess behind the door can also be used to store a power cable during transit. Power is supplied to the IBM P75 through an IEC C14 socket, the PSU accepts 100-240v 3.0A[1][2][5]

The IBM P75, like other contemporary PS/2 computers of the period, utilises reference diskettes to make any changes to system settings such as the installed memory size, the assignment of the built-in connectors, and installed options with their location and assignments. System settings are stored in CMOS and data integrity is maintained through an internal non-rechargeable 6V battery. Should the internal 6V battery run low, the computer may not POST successfully as the internal CMOS contents are corrupted. The reference diskette also includes basic diagnostic software. If the computer is booted without an operating system and/or hard disk, the P75 will boot into IBM Cassette BASIC.[7]

IBM did not ship with any additional operating system, but is fully compatible with OS/2, AIX, MS-DOS, IBM PC DOS and Microsoft Windows.[1]