CSIRAC

CSIRAC (/ˈsræk/; Commonwealth Scientific and Industrial Research Automatic Computer), originally known as CSIR Mk 1, was Australia's first digital computer, and the fifth stored program computer in the world.[1] It is the oldest surviving first-generation electronic computer[2] (the Zuse Z4 at the Deutsches Museum is older, but was electro-mechanical, not electronic), and was the first in the world to play digital music.[3][4][5][6][7][8]

CSIRAC
CSIRAC, Australia's first digital computer, as displayed at the Melbourne Museum
Also known asCSIR Mk 1
TypeDigital computer
Release datec.1949 (1949)
Units shipped1

After being exhibited at Melbourne Museum for many years, it was relocated to Scienceworks in 2018 and is now on permanent display in the Think Ahead gallery.[9] A comprehensive source of information about the CSIRA collection, its contributors and related topics is available from Museums Victoria on their Collections website.[10]

History

The CSIRAC was constructed by a team led by Trevor Pearcey and Maston Beard, working in large part independently of similar efforts across Europe and the United States, and ran its first test program (multiplication of numbers) sometime in November 1949.[11][7] In restricted operation from late 1950, publicly demonstrated and operational in 1951.[12][13][14]

Design

The machine was fairly representative of first-generation valve-driven computer designs. It used mercury acoustic delay lines as its primary data storage, with a typical capacity of 768 20-bit words, supplemented by a parallel disk-type device with a total 4096-word capacity and an access time of 10 milliseconds. Its memory clock ran at 1000 Hz, and the control unit, synchronized to the clock, took two cycles to execute an instruction (later the speed was doubled to one cycle per instruction). The bus (termed the "digit trunk" in their design)[15] is unusual compared to most computers in that it was serial—it transferred one bit at a time.

Most of CSIRAC's approximately 2000 valves were of the types 6SN7,[16] 6V6,[17] EA50 diodes and KT66.[18] George Semkiw later redesigned the drum-read electronics to use germanium transistors.

Input to the machine was performed in the form of punched 3-inch (76 mm) wide, 12-track paper tape,[19] after experiments with punch cards proved unsatisfactory. The machine was controlled through a console which allowed programs to be stepped through one instruction at a time, and featured CRT displays which showed the contents of registers. Output was through a standard teleprinter or to punch tape.

The instruction set supported the basic set of arithmetic and logical operations, as well as conditional and relative jumps (making it possible to write a library of subroutines). Instructions consisted of three components: a 5-bit "destination" P1-P5, a 5-bit "source" P6-P10, and a 10-bit "address" P11-P20. For instructions that used the main store, the six bits P15-P20 selected one of the 64 logical delay lines. Bits P11-P14 determined the time at which 20 bits of data were written to or extracted from the delay line, and thus represented address of a word within the selected delay line. There were 32 destination gates and 32 source gates; the 10 address bits identified a data word within the store if either the source or destination required access to the store. The total number of source and destination combinations, or different instruction functions, was 1024, although only about 256 of these were used often.[20] The machine had three 20-bit registers (A, B and C), two of which were involved in multiplication, one 10-bit register which could link to either half of a word, and a group of 16 20-bit registers, addressed via bits P11-P14. In addition the 20-bit program counter (S register), and the instruction register (K) were accessible.

The machine, like all machines of the era, had no operating system. A high-level interpreted programming language called INTERPROGRAM was developed in 1960 by Geoff Hill. It was similar to early forms of BASIC, which was designed in 1963 for the 20-bit transistorized GE-200 series.

In 1950 CSIRAC was used to play music, the first known use of a digital computer for the purpose. The music was never recorded, but it has been accurately reconstructed.[4][7][8][5][6]

CSIRAC, side view

In 1955, with the CSIRO's decision that computing research was outside its purview, the machine was transferred from its home at the Radiophysics Laboratory at the CSIRO in Sydney, to the University of Melbourne, where it formed Australia's only academic computing facility until late 1956. Many pioneers of computer use in Australia had their first exposure to computing there.

Preservation

In 1964, CSIRAC was shut down for the last time. Its historical significance was already recognised at that stage, and it was placed in storage with plans for its later exhibition in a museum.

The machine was stored in a warehouse through the 1960s and 1970s, before being set up for exhibit at Caulfield Institute of Technology[21] (later the Caulfield Campus of Chisholm Institute of Technology, and later again the Caulfield Campus of Monash University) from 1980 to 1992. It was then returned to storage.

Interest in the machine was revived in the 1990s, as it was realised that many of its developers were aging and history was being lost forever. A conference about the machine was held in 1996.

CSIRAC display at Scienceworks

The machine found a permanent home with Museums Victoria in 2000. It has not been operable since its shutdown, but many of the programs that ran on it have been preserved, and an emulator has been written for it. The curators have decided that, aside from the cost of restoring the device, the huge number of repairs that would be required to make it safe to operate (CSIRAC used 30 kilowatts of power in operation) would detract from its historical authenticity.

After being exhibited at Melbourne Museum for many years, it was relocated to Scienceworks in 2018 and is now on permanent display in the Think Ahead gallery.[9]

CSIRAC is listed on the Victorian Heritage Register and is included in a Heritage Overlay.[2]

It is listed as a National Engineering Landmark by Engineers Australia as part of its Engineering Heritage Recognition Program.[22]

See also

References

References
  1. "CSIRAC". 12 August 2021.
  2. "CSIRAC (COMMONWEALTH SCIENTIFIC AND INDUSTRIAL RESEARCH ORGANISATION AUTOMATIC COMPUTER)". Victorian Heritage Register. Heritage Victoria. H2217.
  3. "CSIRAC: Australia's first computer". Archived from the original on 16 November 2007. Retrieved 21 December 2007.
  4. Fildes, Jonathan (17 June 2008). "Oldest computer music unveiled". BBC News Online. Retrieved 18 June 2008.
  5. "MuSA 2017 - Early Computer Music Experiments in Australia, England and the USA". MuSA Conference. 9 July 2017. Retrieved 18 October 2017.
  6. Doornbusch, Paul (2017). "Early Computer Music Experiments in Australia and England". Organised Sound. Cambridge University Press. 22 (2): 297–307 [11]. doi:10.1017/S1355771817000206.
  7. Doornbusch, Paul (March 2004). "Computer Sound Synthesis in 1951: The Music of CSIRAC". Computer Music Journal. 28 (1): 11–12. doi:10.1162/014892604322970616. ISSN 0148-9267. S2CID 10593824.
  8. Werner, Joel (16 August 2019). "13.1 Electronic music's origin story [BONUS]". Radio National. Australian Broadcasting Corporation. Retrieved 13 May 2021.
  9. "CSIRAC - the world's oldest intact first-generation electronic computer". Museums Victoria.
  10. "CSIRAC Collection". Museums Victoria Collections.
  11. "CSIRAC Chronology: CSIRAC, University of Melbourne". cis.unimelb.edu.au. David Hornsby, Doug McCann, Peter Thorne. 12 August 2021. Retrieved 24 June 2023.{{cite web}}: CS1 maint: others (link)
  12. "9. C.S.I.R.O. Mark I". Digital Computer Newsletter. 4 (4): 6. October 1952.
  13. McCann & Thorne 2000, pp. viii, 2–3, 27, 30, 77, 79–80.
  14. Research, United States Office of Naval (1953). A survey of automatic digital computers. Office of Naval Research, Dept. of the Navy. p. 22.
  15. McCann & Thorne 2000, pp. 8–11, 13, 91.
  16. 6SN7 Double triode, 8-pin, 3.8 W heater
  17. "6V6 Beam Power pentode, 8-pin, 2.8 W heater". Archived from the original on 27 September 2006. Retrieved 19 January 2007.
  18. KT66 Beam tetrode, 8-pin, 8.2 W heater
  19. "CSIRAC paper tape (replica)". Computer History Museum. 2010. Retrieved 13 October 2023.
  20. "CSIRAC design". Archived from the original on 1 April 2018. Retrieved 14 April 2018.
  21. "Slide: CSIRAC Computer, Trevor Pearcey, 1980-1992". Museum Victoria Collections. Item MM 68471. Archived from the original on 13 July 2012.
  22. "CSIRAC Computer, 1949-64". Engineers Australia. Retrieved 27 April 2020.
Bibliography
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.