Ullage (wine)

The "red band" seen on many wine barrels is from wine spill. Some of this spillage comes from the topping off process when the bung is reinserted into the barrel.

At the winery, the natural process of evaporation creates ullage in the barrel by causing some of the alcohol and water particles to escape as vapors, a loss sometimes referred to as the "angel's share". If the wine is in a container that is not completely air-tight, these vapor molecules (along with carbon dioxide) will diffuse out of the container through openings in the wood and around the bung and be replaced with oxygen molecules. While some oxygen is beneficial in the maturation and break-down of some phenolic compounds such as tannin, excessive amounts of oxygen can interact with Acetobacter present in the wine and start the process of turning the wine into vinegar. To prevent this possible oxidation and spoilage wineries will regularly "top up" the barrels by replacing the lost liquid with new wine.[1]

The exact method and timing of topping up a wine barrel is determined by the individual wineries and can depend on the type of wine or grape variety that is being produced. A barrel can be topped off anywhere from once a week to every month and a half. The position of the barrel can affect the speed and degree of evaporation and the need for topping up. If the barrel is sitting with its bung hole on top, aeration and evaporation occurs more quickly. If the barrel is turned to the side in the bung over position, the bung is kept moist with the wine and aeration occurs at a slower pace. The wine that is replaced during the topping up is usually the same wine taken from another smaller container (such as a carboy) with the barrel filled to the very top to where the reinsertion of the bung causes some spillage.[1]

An assortment of aged Bordeaux wine with various ullage levels.

The ullage level of a wine bottle is sometimes described as the "fill level". This describes the space between the wine and the bottom of the cork. During the bottling process, most wineries strive to have an initial ullage level of between 0.2–0.4 inches (5–10mm). As a cork is not a completely airtight sealant, some wine is lost through the process of evaporation and diffusion. As a wine ages in the bottle, the amount of ullage will continue to increase unless a wine is opened, topped up and recorked. If the wine is stored on its side, in contact with the cork, some wine will also be lost by absorption into the cork with longer corks having the potential to absorb more wine (and thus create more ullage) than shorter corks.[1]

Generally the greater the amount of ullage, the more potential that the wine has been exposed to harmful levels of oxidation. This is why auction houses and retailers of mature wines pay close attention to the ullage levels in determining the resale value of the wine. The ullage level can also give insight as to the type of care and storage condition that the wine was kept in. Wines that have been kept at ambient humidity levels and in temperatures between 50–59 °F (10–15 °C) will experience evaporation and diffusion at a slower rate than wine kept in lesser conditions and will thus have a lower ullage levels. Ullage levels are generally important to the likelihood of almost any wine being in good shape. Vintage Port might be slightly less prone to damage since it is fortified, but the only wines that can not be damaged by oxidation are Madeira wines, which are already oxidized.

There are standard descriptions used by wine merchants and auction houses for the fill levels (ullage levels) of wine. The fill levels descriptions are different for Bordeaux and Burgundy wines due to the different shape of the bottles from those two regions.[2]

Broadbent's ullage guide

Commonly used terms for ullage of Bordeaux bottles. (Capsule line appears to indicate depth of cork.)

In the late 1980s, Master of Wine and senior consultant of Christie's auction Michael Broadbent developed a guide for evaluating the ullage levels of matured wines. While the focus of his guide was primarily on Bordeaux, it has been generally accepted and widely used in the wine market as an evaluation tool for all sorts of wine. The terms are used to describe the levels of wine in a wine bottle. They are commonly used to describe old wine bottles offered for sale in wine auctions and by dealers in rare wine. Due to the guide's popularity, Broadbent has been quoted as regretting his decision not to copyright it.[3]

Ullage level (in/cm)	Appearance	Assessment
0.12 in (0.3 cm)	High up to the cork	Normal level for young wines
0.2 in (0.5 cm)	High in neck	Good condition for any age
0.6 in (1.5 cm)	Top of the shoulders	Normal for older wines. Good condition for wines over 15 years
1 in (2.5 cm)	Upper part of shoulders	Generally okay in older wines, especially those over 20 years
1.18–1.38 in (3–3.5 cm)	Mid to mid-low shoulders	Possible oxidation. Price should reflect the risk.
2.36–2.75 in (6–7 cm)	Low shoulders to below shoulders	Extremely risky. Possibly undrinkable