German rocket propelled bombs of World War II

The three types were similarly constructed with a warhead, spacer, and tail sections:

• Warhead – The warhead was of similar construction to other bombs of the period with thin-walled construction and the filling consisted of alternating layers of high and low-quality TNT. The explosive filling was poured through the base of the warhead. The base of the warhead was threaded and it screwed into the spacer.[1]
• Spacer – The purpose of the spacer was to separate the tail unit from the warhead and it contained a delayed action base fuze for detonating the bomb and a black powder ignition charge. The spacer was also threaded and screwed into the tail unit.[1]
• Tail section – The tail section consists of the following parts: pressure chamber, six venturi tubes, six metal spacers at each end of the pressure chamber, and a spring-loaded pressure release valve. The pressure chamber contained 19 sticks of diglycol dinitrate solid-rocket fuel with the propellant gasses being vented through six venturi tubes that were sealed with pitch until ignited. The pressure chamber also has a spring-loaded pressure release valve in the center for safety. The tail unit also had a total of 12 fins with 4 large fins and 8 small fins for stability.[1]

The bombs are normally released from a minimum height of 1,200 m (4,000 ft). When the bomb is released an electrical charge is sent to the charging head. This charge is then passed on to both the pyrotechnic fuze and the impact fuze arming the bomb. The pyrotechnic delay is immediately ignited and after 3 or 4 seconds it burns through to the black powder igniter. The solid-rocket propellant burns for three seconds and produces a trail of flame 46 m (150 ft) long. When the bomb hits the target its delayed action base fuze is triggered and the bomb explodes after penetrating the target. [1]

• 
  PC 500 RS
• 
  PC 1000 RS
• 
  PC 1800 RS

• Disney bomb – A 2-ton British unguided rocket-propelled armor-piercing bomb.