Boundary Dam Power Station

The Boundary Dam Power Station consists of[1] two 62 net MW units (commissioned in 1959, shut down and decommissioned in 2014[2]); two 139 net MW units (commissioned in 1970), one of which—Unit 3—was decommissioned and replaced with a new 160 MW unit in 2013;[3] one 139 net MW unit (commissioned in 1973); and one 273 net MW unit (commissioned in 1978).

The boilers are supplied by Babcock & Wilcox and Combustion Engineering while the turbines/generator are supplied by General Electric and Hitachi.[4] There is also Boundary Dam (constructed in 1957) located next to the station. It is an earth fill dam, which created the Boundary Dam Reservoir on Long Creek a few kilometres west of the river's mouth on the Souris River. The station uses water from the reservoir for coolant, which is why Boundary Reservoir is the only body of water in Saskatchewan that doesn't freeze over during the winter months and supports largemouth bass.[5]

The plant has five 300 ft (91.44 m) tall smokestacks.[6] SaskPower has advised that the project has a 30-year life.[7]

The Boundary Dam Integrated Carbon Capture and Storage Demonstration is a project to retrofit the lignite-fired Unit #3 with a carbon capture system.[8][9][10] It consists of two distinct parts: Repowering of the existing Unit #3 and the installation of the carbon dioxide, sulfur dioxide and NOx capture facility.[11] Its primary purpose is to provide a low-cost source of carbon dioxide, to the mature Weyburn Oil Field, for enhanced oil recovery.[12][13] It is expected to result in a 90 percent (1 million tonnes/year) reduction in CO₂ emissions and will also reduce the output of Unit 3 from 139 MW to 110 MW.[14] Critics point out that the 90% figure refers to the percentage of total CO₂ emissions captured, and that only about a half of this CO₂ will actually be permanently stored. The remainder is released into the atmosphere during capturing and processing in the oil field.[15] The retrofitted unit was officially opened in October 2014,[16] and is the world's first commercial-scale, lignite-fired power plant equipped with carbon capture and storage technology[17][18]

In 2015, internal documents from SaskPower revealed that there were "serious design issues" in the carbon capture system, resulting in regular breakdowns and maintenance problems that led the unit to only be operational 40% of the time. SNC-Lavalin had been contracted to engineer, procure, and build the facility, and the documents asserted that it "has neither the will or the ability to fix some of these fundamental flaws."[19] The low productivity of the plant had in turn meant that SaskPower was only able to sell half of the 800,000 tonnes of captured carbon dioxide that it had contracted to sell to Cenovus Energy for use in enhanced oil recovery at a cost of $25 per tonne. In addition to the lost sales, this meant that SaskPower had been forced to pay Cenovus $12 million in penalties.[20] In June 2016, and to avoid paying a $91-million penalty, SaskPower renegotiated its CO₂ supply contract with Cenovus. That renegotiation means annual revenues are reduced from $25 million to "$16-17 million". Over the 30-year project life this represents reduced revenue of $240 million to $270 million and will further weaken the project economics.[21] Cenovus sold its Saskatchewan interests in 2017 to Whitecap Resources.[22]

Several major publications have noted what they deem poor economics of the project, among them The Economist,[23] The Financial Times,[24] The MIT Technology Review,[25] and The New York Times.[26][27] An April 2016 Parliamentary Budget Office report found that CCS at Boundary Dam doubles the price of electricity.[28]

Financial concerns appear to fall into three main areas:

• negative earnings before interest, taxes, depreciation, and amortization, in part due to the pioneering nature of the project;.[29]
• the existence of cheaper alternatives, such as wind turbines, which urgently need to be developed.[15][30][31]
• the potential for substantial losses for initial investors (Saskatchewan taxpayers and SaskPower ratepayers), in excess of $1 billion [15][32]

Among environmental concerns, critics note that while 90% of CO₂ smokestack emissions are captured, only a portion is stored. Almost half of captured emissions end up being released in the atmosphere by processing in the oil field and the capturing process.[33]

Among other concerns, critics point to the following:

• The foremost goal of the CCS project is to keep the aging plant from becoming a stranded asset.
• The unfair sharing of the costs, risks and benefits: Energy consumers are said to be saddled with a "very expensive carbon tax", while Saskatchewan's aging oil industry, namely Weyburn Consortium (formerly headed by Cenovus Energy), which owned the Weyburn oil field until it was sold in 2017[22] receives a "backdoor subsidy."[15][34]

All of these concerns are compounded by a lack of transparency: As of 2015 the project operators had not presented any financial or environmental performance numbers.

In July 2018, SaskPower announced that it would not retrofit Units 4 and 5 with CCS, with minister responsible Dustin Duncan saying that the units were approaching their mandated shut down in 2024 and that natural gas is a cheaper option.[35]

In February 2008 the Saskatchewan government announced that it would proceed with a 7-year reconstruction and repowering of Boundary Dam's Unit 3. The initial project cost was C$1.24 billion[36] out of which C$240-million was from the federal government.[14][37] Budget over-runs have led to the plant having a total cost of some $C 1.5 billion.[38][39]

Other than the generation of electricity, the plant will have several by-products which will generate revenue.

Sample of solid carbon dioxide or dry ice pellets

There appear to be two main expense items: Operations and maintenance, and parasitic load. In the latter, carbon and sulfur dioxide amine-based capture units, such as the one at Boundary Dam, consume significant amounts of electricity and heat in operation and the largest single component is associated with solvent regeneration.[50] Significant electrical load is also used to run additional emission control components (e.g. NOx and mercury capture) as well as associated pumps and other equipment.

• List of generating stations in Saskatchewan
• Coal mining in Saskatchewan
• Shand Power Station

• SaskPower Station Description